Campbell Hausfeld PW320200 Manual De Instrucciones página 12

ASSEMBLY INSTRUCTIONS (FIGURES 15 AND 16)
1. Locate and remove all loose parts from the carton.
2. Cut four corners of the carton from top to bottom and lay the
panels flat.
3. Place handle (G) onto frame (H),depress the snap buttons, and
slide the handle assembly onto the frame until snap buttons
snap into place.
prevent pinching.
4. Remove the colored quick-connect nozzles (K)
from the plastic bag and insert them into correct
grommet on the nozzle holder. Nozzles are color
coded to match colored nozzles on label.
5. Connect wand (E) to gun (D). Tighten securely.
6. Attach high pressure hose (C) to gun (D). Tighten
se cure ly.
warranty.
NOTE: The pump on this unit is maintenance free and requires no oil. If there is a problem with the pump,
contact our Customer Service Group on www.campbellhausfeld.com as soon as possible.
OPERATING INSTRUCTIONS
Pressure Washer Terminology
PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic
pressure, etc.
GPM: Gallons per Minute. The unit of measure for the flow rate of water.
CU: Cleaning Units. GPM multiplied by PSI equals CU.
Bypass Mode: Allows water to re-circulate within the pump when the gun trigger is not pulled. This feature
allows the operator to release the trigger gun and reposition themselves without having to turn the engine
off in between cleaning actions.
rises too high, the thermal relief valve will open and release a spray of water from the pump to lower the internal
temperature. The valve will then close.
Thermal Relief Valve (Figure 17): When the temperature inside the pump rises too high, this
valve will open and release a gush of water in an effort to lower the temperature inside the
pump. The valve will then close.
Detergent Injection System: Mixes cleaners or cleaning solvents with the water to improve
cleaning effectiveness.
Water Supply: All pressure washers must have a source of water. The minimum requirements for a water
supply are 20 PSI and 5 Gallons Per Minute. If your water source is a well, the garden hose length can only
be 30 ft. (9 m) max.
Risk of personal injury. Avoid placing hands
between handle and frame when assembling to
The engine is shipped without oil. Before starting engine, add the oil provided. Damage to the
engine will occur if the engine is run without oil, this damage will not be covered under
Do not allow the unit to run for more than two minutes without the gun trigger being pulled.
This could cause overheating and damage to the pump. When the temperature inside the pump
To reduce the possibility of contamination always protect against backflow when connected to
a potable water system.
10
G
H
Figure 15
E
D
Figure 16
K
D
C
L
Figure 17