Error Messages - MARQUES BM 1000 Guía De Usuario

E N
WEIGHING
• Ensure that the scale presents zero weight before making any
weighing operations. Correct it with the 'Zero' key if necessary.
• Place the product on the weighing platform, the weight appears
on the indicator.
• If a container must be used, place it on the load receptor and use the
'Tare' or 'Fix' key to reset the display to zero indication;
• Once the weight indication is reset, the load can be placed for normal
weighing operation. The respective 'Tare' or 'Fix' and 'Net' symbols
will be active as a reminder.
• Press 'Tare' or 'Fix' accordingly to remove tare and reset the display
back to zero when all load is removed from the load receptor.
Any weight readings or tare operations must be done only with the 'Stable weight'
indicator on.

ERROR MESSAGES

POSSIBLE CAUSES
• The load receptor is not empty, or it is
obstructed when powering on;
• No signal from the load receptor or
the load receptor sensor is damaged.
• The load receptor is exceeding its
capacity limits.
• Unknown anomaly.
• Weighted sample is too low.
Contact technical support if the problem continues.
1 0
B M 1 0 0 0 – U S E R G U I D E
SOLUTIONS
• Remove any load from the load
receptor, inspect for any obstructions;
• Inspect the load receptor cable and
connection to the instrument.
• Remove excessive load from the
load receptor and inspect for any
obstructions.
• Increase the sample weight on the
load receptor.
1 1 / 2 0 1 8 , R E V . 1 . 0
U S E R G U I D E - B M 1 0 0 0
BATTERY OPTION
If the instrument is equipped with an internal battery, in case of a mains power
failure or disconnection, the battery symbol will become visible indicating that the
instrument is using the internal battery as power source.
When the battery fully discharged, the instrument will emit a warning sound and the
'-off-' message, indicating that the battery should be fully charged immediately and
that the instrument will power itself off in short term.
Whenever the instrument is connected to the mains AC power, the internal battery
charging module will still be able to fully manage the battery power, even in the off state.
The battery status can be
checked by means of the
<Esc> key. Repeatably press
this key to access the status
messages or to return to the
main display.
Always fully charge to assure a longer battery life. Minimum charging time is 5
hours, charging up to 7 hours will extend its life cycle. Drained batteries deterio-
rate very fast to an irrecoverable state, fully charge immediately after use. Avoid
deep discharges. Avoid extreme temperature conditions.
1 2 / 2 0 1 8 , R E V . 1 . 0
E N
Battery is charging
% of battery charging level
Battery is fully charged
Battery is discharging
% of remaining battery level
Battery recharging is needed
Battery error
No battery installed
The instrument will power off
1 1