Specifications - Pinnacle Protemp PT-80V-LPC Manual De Usuario E Instrucciones De Funcionamiento

– ALWAYS install the heater so that it is not directly
exposed to water spray, rain, dripping water, or
wind.
– Use heater in accordance with all local codes.
In the absence of local codes, refer to The
National Fuel Code, ANSI Z223.1.
For use with propane (LP)
WARNING
gas only.
– This heater is shipped from the factory for use
with propane (LP) gas only. Do not convert
to any other gas. Installation must conform
to local codes, or in their absence, with the
standard for the Storage and Handling of
Liquefied Petroleum Gases ANSI/NFPA 58
and the Natural Gas and Propane Installation
Code CSA B149.1.
– Gas supply connections should be checked by
using a 50/50 soap and water solution. Never
use a flame to check for gas leaks.
RISK OF FIRE! ALWAYS LOCATE HEATER ON A STABLE AND LEVEL SURFACE!
WARNING
(SEE FIGURE 1)
Figure 1
Model #
BTU
Fuel Consumption (Lbs./hr)
Heat Settings
Maximum Operating Hours
Required Cylinder Lbs.
Fuel Type
Heating Area (Ft. )
2
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE CONNECTED
®
SAFETY INFORMATION (CONT.)

SPECIFICATIONS

PT-80V-LPC
60,000 / 70,000 / 80,000
2.8 / 3.2 / 3.7
Propane
Specifications subject to change without notice.
TO A FUEL SOURCE
WARNING
material and contact with hot surfaces both during
use and while in storage.
– Locate LP cylinder at least 6 feet (10 ft. in
Canada) from the heater, and do not direct
heater discharge towards the LP cylinder
unless it is at least 20 feet from the heater.
– Use only the regulator and hose assembly
provided with this heater. Inspect the
regulator/hose assembly prior to each use of
the heater. If there is excessive abrasion or
wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list, prior
to using the heater.
Minimum and Maximum Inlet Pressure
Min.
Max.
X
3
36
100
1800
4
The hose assembly shall be pro-
tected from traffic, building
PT-80V-LPC PT-200V-LPC
5 PSI
Bottle Pressure
PT-200V-LPC
70,000 – 200,000
3.2 / 9.3
Variable
31
100
Propane
5000
Convection Heater User's Manual