GE JGP637 Manual Del Usuario página 14

Installation
Instructions
If you have questions, call 1.800.GE.CARES
In the Commonwealth of Massachusetts:
• This product must be installed by a
licensed plumber or gas fitter.
• When using ball-type gas shut-off valves,
they shall be the T-handle type.
CAUTION: Before you begin—read these
instructions completely and carefully.
• IMPORTANT—Save these instructions for
local inspector's use.
• IMPORTANT—OBSERVE ALL GOVERNING
CODES AND ORDINANCES.
• Note to Installer—Be sure to leave these
instructions with the Consumer.
• Note to Consumer—Keep these instructions
for future reference.
PARTS INCLUDED
2 screws Foam
Tape
TOOLS YOU WILL NEED
1/8" Drill Bit &
Electric or
Hand Drill
2 Hold
Down
Brackets
Flat-Blade Screwdriver
Phillips
Head
Screwdriver
36" Sealed Gas Cooktop
or
visit our Website at:
• A flexible gas connector, when used,
must not exceed 3 feet.
• Note—This appliance must be properly
grounded.
• IMPORTANT: Leak testing of the appliance
shall be conducted according to the
manufacturer's instructions.
• Skill level—Installation of this appliance
requires basic mechanical skills.
• Proper installation is the responsibility of
the installer.
• Product failure due to improper installation
is not covered under the Warranty.
MATERIALS YOU MAY NEED
Pipe Fittings
Pipe Wrench
Pencil Ruler or
Straightedge
14
ge.com
Shut Off
Valves
Joint Sealant
Saber Saw