Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
skirt ( ) up the barrel (B) all the way to the back edge of the knurled ring (E). If it will not go up all the way, the skirt ( ) will have to be
turned while pushing it forward until it re-aligns with the ribs on the large plastic focusing ring (D). Once it slips over these ribs it will
go all the way up to the back of the knurled ring (E). Once the skirt ( ) is against the knurled ring (E), again push the skirt forward to
close the gap between the knurled ring (E) and the face cap (F) and turn the knurled ring (E) 1/16th turn in either direction; then release
the forward pressure on the skirt and continue turning the knurled ring (E). You should hear / see the skirt push back into the locked
position. When the skirt ( ) is back in its locked position, turning it will focus the light from spot to flood as usual.
NOTE: If the knurled ring (E) is moved forward and turned while the skirt is out of position, the mechanism could lock and prevent the
skirt from returning to its normal position. If this occurs, push the knurled ring forward (toward the flashlight's head) and turn it slightly
(it will require less than 1/16 inch of a turn) until it clicks and backs away from the face cap (F). Then return the skirt to its normal position
by following instruction #4.
8
M GLITE
®
ML125™ LED FL SHLIGHT SPECIFIC TIONS
Overall Length:
11.104 in.
282.042 mm
Barrel Diameter:
1.199 in.
30.455 mm
Head Diameter:
1.977 in.
50.216 mm
Weight without battery:
11.2 oz.
317.514 g
Weight with battery:
18.4 oz.
521.631 g
Batteries Required: (3) C-Cell size alkaline or supplied
NiMH rechargeable battery pack
-
NiMH Rechargeable Battery
-
+
+
-
C-Cell Alkaline
C-Cell Alkaline
1
2
3
1
Tail cap
4
**Barrel ssembly
Capuchon
**Tube ssemblée
d'assemblage
**Cilindro Montaje
Tapa posterior
5
Switch seal
2
Lip Seal, tail cap
Joint commutateur
Joint, à lèvre
Bouchon rrière
Sello del interruptor
Sello del Labio,
6
Lip Seal, face cap
tapa posterior
Joint, anneau avant
3
Battery spring*
tapa delantera
Ressort pour pile*
Sello del Labio,
Resorte para pilas*
*Item 3 inserts into item 1 • La pièce 3 doit être insérée dans la pièce 1 • Inserte la pieza 3 dentro de la pieza 1
**Do not disassemble. *Ne pas désassembler. *No desarmar.
Runs on either NiMH rechargeable
+
battery (included) OR (3) - ell alkaline
batteries (not included)
+
-
C-Cell Alkaline
5
4
6
8 9
7
Reflector
Réflecteur
Reflector
8
Clear lens
Lentille incolore
Lente transparente
9
O-ring, face cap
Joint, anneau avant
Rondana, tapa delantera
10 Face cap
nneau avant
Tapa delantera
10
Publicidad
Tabla de contenido
