Connecting Your Ice Maker; Using Your Ice Cream Maker - Hkoenig KB12 Manual De Utilización

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

CONNECTING YOUR ICE MAKER

DANGER : * Improper use of the grounded plug can result in the risk of electrical shock. If
the power cord is damaged please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this appliance is
equipped with a grounding plug which mates with standard grounding wall outlets to minimize
the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounding wall outlet. Do not under
any circumstances, damage the grounding means of the plug under any circumstances. Any
questions concerning power and/or grounding should be directed toward a certified electrician.
3. This appliance requires a standard 220-240Volt, 50Hz electrical outlet with good grounding
means.
CLEANING AND MAINTAINING YOUR ICE CREAM
Unplug the ice maker before cleaning or making any
repairs or servicing.
Before using your ice maker, it is strongly recommended to
clean it thoroughly.
1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and
a soft cloth.
3. Then use the water to rinse the inside parts, and drain out
the water by unplugging the drain cap on front bottom
side.
4. The outside of the ice maker should be cleaned regularly
with a mild detergent solution and warm water.
5. Dry the interior and exterior with a clean soft cloth.
6. When the machine is not to be used for a long time, drain
water completely & dry the interior.

USING YOUR ICE CREAM MAKER

1. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the MAXIMUM water level mark.
2. Press "ON/OFF" button on the control panel to begin the ice making cycle.
3. Select the ice cube size by pressing the "SELECT" button. If the room temperature is lower than
15℃, it is recommended to select small ice cube in order to avoid ice sticking together.
4. The ice making cycle lasts approx. 6 to 13 minutes, depending on seletion of ice cube size and
the room temperature. The recommended room temperature is 10℃ to 43℃
5. If water pump can't inject water, the ice maker will stop automatically, and the "Add Water"
indicator will be on.Press "ON/OFF" button, fill water up to the max. water level mark and press
"ON/OFF" button again to turn on the unit again.Allow the refrigerant liquid inside the

Publicidad

Tabla de contenido
loading

Tabla de contenido