Troubleshooting Chart
Sensor obstruction
Dryer fails to start.
No power to the unit
Faulty Circuit Board and Sensor
Faulty Motor
Sensor obstruction
Dryer will not shut off
or runs 20-30 seconds,
then will not re-start
Sensor receiving false signal or
reflection
Dryer "Ghosts" starts
Fluctuating power supply
with no hands present
Dryer mount on wall loose
Motor noisy or vibrates
Faulty Motor and Fan
Air intake blocked
Dryer air too hot
Dirty air filter
Limited Warranty
World LIMITED FIVE– YEAR WARRANTY. World dryer™ warm air hand dryers, covered in this manual, are warranted by world dryer corporation to the
original owner against defects in workmanship or materials under normal use for five years and three years for electronic controls after the date of purchase. Normal
wear or abuse of any component is excluded from this warranty. Any part which is determined to be defective in material or workmanship and returned, shipping costs
prepaid, will be, as the exclusive remedy, repaired or replaced at world's option. For limited warranty claim procedures, see "prompt disposition" below. This limited
warranty gives purchasers specific legal rights which vary from jurisdiction to jurisdiction.
LIMITATION OF LIABILITY. To the extent allowable under applicable law, World's liability for consequential and incidental damages is expressly disclaimed.
World's liability in all events is limited to and shall not exceed the purchase price paid.
WARRANTY DISCLAIMER. World has made a diligent effort to provide product information and illustrate the products in this literature accurately; however,
such information and illustrations are for the sole purpose of identification, and do not express or imply a warranty that the products are MERCHANTABLE, or FIT FOR
A PARTICULAR PURPOSE, or that the products will necessary conform to the illustrations or descriptions. Except as provided below, no warranty or affirmation on
fact, expressed or implied, other than as stated in the "LIMITED WARRANTY" above is made or authorized by World.
PRODUCT SUITABILITY. Many jurisdictions have codes and regulations governing sales, construction, installation, and/or use of products for certain purposes,
which may vary from those in neighboring areas. While World attempts to assure that the products comply with such codes, it cannot guarantee compliance, and can-
not be responsible for how the product is installed or used. Before purchase and use of a product, review the product application, and all applicable national and local
codes and regulations, and be sure that the product, installation, and use will comply with them.
Certain aspects of disclaimers are not applicable to consumer products; e.g., (a) some jurisdictions do not allow the exclusion or limitation of incidental or consequen-
tial damages, so the above limitation or exclusion may not apply to you; (b) also, some jurisdictions do not allow a limitation on how long an implied warranty lasts,
consequentially the above limitation may not apply to you; and (c) by law, during the period of this Limited Warranty, and implied warranties of implied merchantability
or fitness for particular purpose applicable to consumer products purchased by consumers, may not be excluded or otherwise disclaimed.
Manufactured by World Dryer Corporation, Berkeley, Illinois 60163 U.S.A.
PROMPT DISPOSITION. World will make a good faith effort for prompt correction or other adjustment with respect to any product which proves to be defective
within limited warranty. For any product believed to be defective within limited warranty, first write or call dealer from whom the product was purchased. Dealer will
give additional directions. If unable to resolve satisfactorily, write to World at address below, giving dealer's name, address, date, and number of dealer's invoice, and
describing the nature of defect. Title and risk of loss pass to buyer on delivery to common carrier. If product was damaged in transit to you, file claim with carrier.
1. Check Sensor Lens for foreign material or dirt. Clean lens with soft damp
cloth and mild cleaning agent
2. If Lens is damaged or scratched, replace it
Check if power is "ON"; Check electrical connections
Listen for PCB Relay "Click"; If no "Click" is heard, replace the PCB and Sensor
If Relay "Click" is heard, but unit does not start, replace the Motor / Fan assembly
1. Check Sensor Lens for foreign material or dirt. Clean Lens with soft damp
cloth and mild cleaning agent
2. If Lens is damaged or scratched, replace it
1. Hand Dryer should be mounted a minimum of 18" above a reflective surface
2. Check if other Infrared operated appliances in the vicinity may be triggering
the Dryer
3. Replace the PCB and Sensor
1. Multiple Hand Dryers on one circuit or Dryers sharing a lighting circuit.
Automatic Hand Dryers must be on dedicated circuits
2. Building wiring may be insufficient gauge or too long of a run from the supply
Check if mounting screws are tight and dryer is solid to wall
Replace Motor and Fan Assembly
Inspect for and remove foreign material blocking air intake slots. Using a soft
brush and vacuum, clean intake slots
Clean or replace air filter. To clean, remove and use a soft brush and vacuum to
remove all foreign material. If air filter cannot be completely cleaned, replace it
340 County Line Road
Bensenville, IL 60106 U.S.A.
800-323-0701
www.worlddryer.com
6