During Maintenance - Cleco mPro400GCD-P Manual De Instrucciones

During remote-start operation (multiple tool setup) an inter-
ruption of TSNet bus leads to a delayed stop of the spindle/
tool. This delay is 2 seconds.Danger due to unexpected
start of the motor or due to an expected but missing stop.
Despite redundant controller parts and monitoring func-
tions, an unexpected start of the machine can occur in very
rare cases. Possible reasons: Remote control of diagnostic
functions, bit dump in the memory of the controller.
Mechanical hazards such as jars/jolts due to counter
torques; risk of injury due to winding up and seizing can
result from the nutrunner.
Use the tool at the designated grip points.

Use prescribed counter torque absorbers. For torques,

see Instruction manual tool.
After switching on the nutrunner controller, wait until the

boot cycle is completed. This usually takes about
60 sec. Only then switch off / on again.

During maintenance

Consider local regulations for maintenance and servic-

ing for all operating phases of the tightening system.
The nutrunner control is generally maintenance-free.
When cleaning
Only clean the tool and the nutrunner controller from

the outside with a damp cloth.
Do not immerse the tool and nutrunner controller in

water or cleaning agents.
Do not use a high pressure cleaner.

EN
At the repair
Send the complete nutrunner controller for repair to

your Sales & Service Center.
At disposal
Components of the tightening system present risks to
health and the environment. The tightening system con-
tains components that can be recycled, as well as compo-
nents that have to be disposed of specifically.
Follow the locally applicable regulations.

Separate the components and dispose of them by seg-

regating them clearly.
Collect auxiliary materials (oils, greases) when draining

and dispose of them properly.
Separate the components of the packaging and dis-

pose of them unmixed.
Hand in the nutrunner and the defective nutrunner con-

troller at your company collection point or return to the
Sales & Service Center.
Observe generally valid disposal guidelines
such as, in Germany, the Electrical and Elec-
tronic Equipment Act (ElektroG) and the Bat-
tery Act (BattG):
Used up batteries must be disposed of.

Hand in the batteries at your company
collection point or return to the Sales &
Service Center.
18
P2300HW
2018-03