Napa CARLYLE TW1 Manual Del Usuario página 2

WARNING - FOLLOW THESE RULES FOR SAFE OPERATION!
FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN INJURY
this instruction MAnuAl contAins iMportAnt sAfety inforMAtion. reAd this instruction MAnuAl cArefully
And understAnd All inforMAtion before operAting this tool.
WARRANTY
BREAK BACK TORQUE WRENCH - LIMITED 1 YEAR WARRANTY
Carlyle Professional Hand Tools warrants to the original purchaser that the company's break back torque
wrenches are free from defects in material or workmanship during the 1 year warranty period. We will repair any
break back torque wrench which fails to give satisfactory service due to defective workmanship or materials
(excluding calibration) for 1 year from the date of original purchase. (Calibration is only covered by this warranty
for each new unused torque wrench out of the box.) Products must be returned with proof of purchase, freight
prepaid, to the warranty service center listed below.
This warranty excludes torque wrenches which have been subjected to abnormal use, accident, neglect, or lack
of maintenance. Any modification, disassembly of this wrench or repair by an unauthorized service center will
void the warranty.
This warranty gives you specific rights. You may also have other rights which vary from state to state.
The foregoing obligation is Carlyle Professional Hand Tools sole liability under this or any implied warranty and
under no circumstances shall Carlyle Professional Hand Tools be liable for any incidental or consequential
damages.
Note: Some states do not allow the exclusion or limitation of incidental or consequential damages so the above
limitation or exclusion may not apply to you.
For Warranty Service and Recalibration/Certification Services, contact:
TW1
• To safeguard torque accuracy avoid keeping tool set at high loads for long periods of time.
When finished reset back to zero.
• Do not operate without eye or hand protection.
• Keep body working stance balanced and firm. Do not overreach when operating the tool.
• Keep fingers and hands away from pinch point region of this tool at all times.
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.
• Do not force tool beyond its rated capacity. Use of a "cheater bar" or leverage multipliers will result in an
inaccurate reading and can possibly damage the wrench. Use of unapproved accessories could push the
unit beyond its rated capacity and will void your warranty.
• Do not use torque wrench to loosen fasteners.
• The wrench should be sent in for calibration once every year or every 5,000 cycles for re-calibration.
• The wrench should be cleaned and stored properly after every use.
• Wrenches should be re-calibrated if dropped or accidentally mishandled.
• The torque wrench should be "exercised" a minimum of three times at 100% of full scale before use.
• Do not remove any labels. Replace damaged labels.
Torque Wrench Repair Facility
315 Hawkins Rd.
Travelers Rest, SC 29690
Phone: 866.496.8423 • Fax: 864.834.6651
2 Rev. 10/25/12