Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TROuBLESHOOTING
Common Audio/Visual Problems
Problem
Explanation/Recommendation
Buzzing sound in audio
Some inexpensive stereo systems and boom boxes make a buzzing
systems
sound when operated from the inverter, because the power supply in
the electronic device does not properly filter the modified sine wave
produced by the inverter. The only solution to this problem is to use a
sound system that has a higher quality power supply.
Problem: Television
The inverter is shielded to minimize interference with TV signals.
Interference
however, in some instances, some interference may still be visible,
especially when the TV signal is weak. Try the following to improve the
picture:
1. Move the Inverter as far away as possible from the TV set, the
antenna, and the antenna cables. Use a short AC extension cord, if
necessary.
2. Adjust the orientation of the antenna cables, and the TV power cord
to minimize interference.
3. Make sure that the antenna feeding the TV provides an adequate
(snow-free) signal and that high quality, shielded antenna cable is
used.
Fault Conditions
Input
Output
Possible Cause
LED
LED
Color
Color
Yellow
Low input voltage
Red
Battery voltage below
10.5 volts
Red
Equipment being
operated draws too
much power
Red
Inverter in thermal
shutdown condition
Red
AC output is shorted
Red or Yellow Fault LED Indicator Lights
The red Fault LED indicates inverter shutdown from input fault, over temperature fault or overload /
short circuit fault and the yellow Fault LED indicates an input fault.
ACCESSORIES
Recommended accessories for use with your charger are available from your local dealer. If you need
assistance regarding accessories, please call: 1-877-571-2391.
WARNING: The use of any accessory not recommended for use with this charger could be
hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the
manufacturer at -1-877-571-2391.
Recommendation
Start Engine
Recharge battery or check DC power supply.
Reduce load to maximum 800 watts.
Allow inverter to cool down. Ensure there is adequate
ventilation around the load is no more than 800 watts for
continuous operation.
Unplug the AC appliance. Disconnect the unit from any 12
volt DC power source. Check the appliance cord. Refer to
the Service Information section that follows.
8
FuLL ONE-YEAR HOME uSE WARRANTY
Black & Decker (U.S.) Inc. warrants this product for one year against any defects in material or
workmanship. The defective product will be replaced or repaired at no charge in either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from whom it was
purchased (provided that the store is a participating retailer). Returns should be made within the time
period of the retailer's policy for exchanges (usually 30 to 90 days after the sale). Proof of purchase
may be required. Please check with the retailer for their specific return policy regarding returns that
are beyond the time set for exchanges.
The second option is to take or send the product to a Black & Decker owned or authorized Service
Center for repair or replacement at our option. Proof of purchase may be required. Black & Decker
owned and authorized Service Centers are listed under "Tools-Electric" in the yellow pages of the
phone directory and on our website www.Baccusglobal.com.
This warranty does not apply to accessories. This warranty gives you specific legal rights and you
may have other rights which vary from state to state or province to province. Should you have any
questions, contact the manager of your nearest Black & Decker Service Center. This product is not
intended for commercial use.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call
1-877-571-2391 for a free replacement.
SPECIFICATIONS
Maximum Continuous Power:
800 watts
Surge Capacity:
1600 watts
Input Voltage:
12.8 volts
Output Voltage:
Approx. 115 volt AC RMS 60 hz
Low Voltage Alarm:
< _ 11.0 volts DC
Low Voltage Shutdown:
10.5 ± 0.3 volts DC
Thermal Shutdown:
Automatic
Wave Form:
Modified Sine Wave (MSW)
Output Connection:
North American Standard Receptacles
Fuses:
Internal
Input Cables:
Battery clip cables
Operating Temperature:
10-20°C (50-68°F)
Storage Temperature:
0-40°C (32-104°F)
Operating/Relative humidity:
5-95% non-condensing
Imported by Baccus global, 595 S. Federal highway, Suite 210, Boca Raton, FL 33432
www.Baccusglobal.com • 1-877-571-2391
9
Publicidad
Tabla de contenido
