Checklist Before Starting Engine - Briggs & Stratton Speed Clean 2800PSI Manual Del Propietário

Ocultar thumbs Ver también para Speed Clean 2800PSI:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: Remove and discard all pump shipping caps before
attaching hoses.
2.
Attach other end of high pressure hose to high
pressure outlet on pump (Figure 5).Tighten by hand.
Figure 5 — Connect High Pressure Hose to Pump
3.
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 6). Clean screen if it contains
debris or replace if damaged. DO NOT run pressure
washer if inlet screen is damaged.
Figure 6 — Connect the Garden Hose to Water Inlet
4.
Run water through your garden hose for 30 seconds
to clean out any debris.
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
SpeedClean™ 2800 PSI Pressure Washer
Inspect inlet screen,
DO NOT use if
damaged, clean if dirty.
5.
Connect garden hose (not to exceed 50 feet in length)
to water inlet.Tighten by hand (Figure 6).
CAUTION
There MUST be at least ten feet of unrestricted garden
hose between the pressure washer inlet and any flow
shut off device, such as a 'Y' shut-off connector or other
convenience-type water shut-off valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6.
Turn ON water and squeeze trigger on gun to purge
pump system of air and impurities.
WARNING
High pressure spray can cause paint chips or
other particles to become airborne.
• Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate eye protection.

Checklist Before Starting Engine

Review the unit's assembly to ensure you have performed
all of the following.
1.
Make sure handle is in place and secure.
2.
Check that oil has been added to proper level in
engine crankcase.
3.
Add proper fuel to fuel tank.
4.
Check for properly tightened hose connections.
5.
Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
6.
Provide a proper water supply at an adequate flow.
7.
Be sure to read "Safety Rules" and "How To Use Your
Pressure Washer" before using the pressure washer.
8

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Speed clean020212-0

Tabla de contenido