Connect Hose And Water Supply To Pump; Important; Checklist Before Starting Engine - Briggs & Stratton GENERAC 2300PSI Manual Del Propietário

• Slowly add "UNLEADED" regular gasoline to fuel tank.
Use a funnel to prevent spillage. Slowly fill tank to about
1.5" below the bottom of the filler neck (Figure 2).
Figure 2 — Typical Fuel Expansion Space
• Install fuel cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
Pump
IMPORTANT: You must attach all hoses before you start
the engine. Starting engine without all hoses connected and
water supplied will damage the pump.
NOTE: Your pressure washer comes with a quick connect
to attach the high pressure hose to the spray gun.
• Uncoil the high pressure hose and attach the female
quick connect to one end of the hose. Pull down on the
collar of the quick connect, slide onto the spray gun and
let go of collar (Figure 3). Pull on hose to be sure of a
tight connection.
Figure 3 — Connect High Pressure Hose to Spray Gun
• Attach the other end of the high pressure hose to the high
pressure outlet on the pump (Figure 4).Tighten by hand.
Figure 4 — Connect High Pressure Hose to Water Outlet
Generac Portable Products 2300 PSI Pressure Washer
• Before you connect your garden hose to the water inlet,
Tank
Fuel
• Run water through the garden hose for 30 seconds to
IMPORTANT: Do Not siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
• Connect the garden hose to the water inlet.Tighten by
CAUTION!
unrestricted garden hose between the pressure washer
inlet and any flow shut off device, such as a 'Y' shut-off
connector or other convenience-type water shut-off valve.
Damage to pressure washer resulting from disregarding this
caution will not be covered by the warranty.
• Turn ON the water and squeeze the trigger on the spray

Checklist Before Starting Engine

Review the unit's assembly to confirm you have performed
all of the following:
• Make sure the handle is in place and secure.
• Check that oil has been added to the proper level in the
• Add the proper gasoline to fuel tank.
• Check for properly tightened hose connections.
• Check to make sure that there are no kinks, cuts, or
• Provide a proper water supply at an adequate flow.
• Be sure to read "Safety Rules" and "How To Use Your
6
inspect the inlet screen (Figure 5). Clean the screen if it
contains debris, replace it if it is damaged. DO NOT RUN
THE PRESSURE WASHER IF THE SCREEN IS DAMAGED.
Figure 5 — Connect Garden Hose to Water Inlet
clean out any debris.Turn off water.
hand (Figure 5).
There MUST be at least ten feet of
gun to purge the pump system of air and impurities.
CAUTION!
Before starting the pressure washer,
be sure you are wearing adequate eye protection.
engine crankcase.
damage to the high pressure hose.
Pressure Washer" before using the pressure washer.
Inspect inlet
screen. Do Not
use if damaged;
clean if dirty.