Tabla de contenido
Publicidad
Overview
Vibrator Models
Electrical Requirements
100-120 V/50-60 Hz
220-240 V/50-60 Hz
Set-Up: Initial Test Without Filler
A test of the Vibrator should be done without the Filler in place. All parts mentioned below are identified on page 8.
1.
Place Vibrator on a solid table.
2.
Make sure ON/OFF switch is OFF.
3.
Make sure Speed Control Regulator (see page 8) is set to LOW.
4.
Insert plug in socket on back of Vibrator and connect it to electric supply.
5.
Turn ON the ON/OFF switch.
6.
Rotate Speed Control Regulator to gradually increase vibrations.
7.
Turn ON/OFF switch to OFF to stop vibration.
Rear view
* If you use a different plug,
please note the Vibrator comes with a C14 Inlet
(standard inlet on desktop computers).
Plug Type *
US
EU
C14 Inlet plug
5
Publicidad
Tabla de contenido
