Publicidad
Idiomas disponibles
Idiomas disponibles
3.2. Emptying the tank and cleaning the cyclonic filters
Caution: The unit must be unplugged before removing the tank.
Remove the tank using the side handles and withdraw the filter block as indicated below.
3.2.1. Tank
3.2.2. Filters
The HEPA and PRO-TECTA filters can be washed and re-used. They can be washed with water and neutral soap.
The filters must be completely dry before being put back.
The HEPA filter must be replaced if damaged or after two washes.
The PRO-TECTA filter must be replaced if damaged or after five washes.
For C.Axpir Digital: once the filters replaced in the correct position, reset the HEPA indicator:
Press the MODE button until the indicator of HEPA filter appears, then press the RESET button and maintain
pressed for 10 seconds before disconnect the device from the power supply, then reconnecting.
2018-07_11070608-A_Notice_Installation_C_Axpir.indd 19
1.
Detach the tank by pulling the handles upwards
2.
Remove the cyclonic cone
3.
Empty the tank
4.
Follow procedure 3.2.2 if your filters are clogged
5.
Make sure that the cyclonic cone is reinserted
correctly before putting the tank back
19
EN
24/01/2019 17:57
Publicidad
Capítulos
