Leaksmart ™ Wireless Leak Sensor; Operation - WINK leakSMART Manual De Instalación Y Operación

leakSMART

Operation

State
Insert
3
x
batteries
Ready to
pair
Pairing
successful
Working and
: 30s
connected
Water
detected
Battery low
CAUTION: Read installation instructions BEFORE installing batteries in your leakSMART
Wireless Leak Sensor
™
Blue Light
3 seconds steady
Fast blinking; will
remain in this state and
repeat blinking pattern
for two minutes
Blue light blinks slowly
five times
Blue light blinks once
every 30 seconds
Blue light blinks twice
per second (no pause)
until out of alarm
condition
Blue light flashes twice
per 30 seconds
Audible Alarm Notes
Brief chirp as
Press the button and the
battery hits
sensor is ready to pair
metal contacts
If the light stops blinking,
Silent press button to enter
pairing mode
Slow beeping
for five seconds
Silent
When water is detected,
Five quick beeps; the leakSMART
pause; repeat automatically shut off in less
until out of than 5 seconds; you will also
alarm condition receive notification on your
mobile device
Chirp every
5 minutes
Valve or Sensors.
™
Valve will
™
8