Power Cable Connection - Uline H-7978 Manual De Instrucciones

2. Insert the label
roll onto a paper
roll spindle, and
place paper roll
into printer.
(See Figure 2)
3. Place tab on
label roll spindle
inside the paper
roll mount.
(See Figure 3)
4. Place the paper roll into the internal label roll
mount. Ensure the paper printing side faces up.
(See Figure 4)
Figure 4

POWER CABLE CONNECTION

1. Make sure the printer power switch is off.
2. The printer power jack is a three-pin socket
for 24V DC power input. (See Figure 5)
Plug the DC cord connector into the
printer's power jack properly.
CAUTION!
• When connecting or disconnecting the plug,
always hold the plug but not the cord.
• Avoid pulling the power cord to prevent cord
damage, fire or electrocution.
• Avoid placing power cord around other
overheated equipment to prevent power
cord melting, which may cause a fire or
electrocution.
• Unplug the printer when not in use.
PAGE 4 OF 24
SETUP CONTINUED
Figure 2
Figure 3
Label Roll
Mount
DATA CABLE CONNECTION
1. Make sure the printer power switch is off.
2. Plug the data cable connector into correct interface.
3. Plug the other end of the data cable into the host
computer.
CAUTION! Do not plug in the data cable when
the printer is on.
NOTE: To install adhesive paper or label roll, see
Label Roll Installation on page 3.
There are five power-on utilities to set up and test printer
hardware. These utilities are activated by pressing the
feed button and pause button.
PRINTER SETUP WITH LP7510
DISPLAY INDICATOR
1. Use the gray interface cable provided with the
printer. Connect cable to LP7510 and the printer.
2. Press and hold the print and total keys down
together for approximately two seconds. The meter
will display
3. Press the zero key until the meter shows
press the lb/kg key once. The zero should be flashing.
Then, press the zero key once. The meter should be
showing
the left, right, up and down arrow keys to program
the current date: left to right, year/month/day.
4. After the date is programmed, press the print key
twice to set the time. Using the arrow keys again to
program in the current time.
5. After the time has been set, press the print key twice.
The meter will display
meter shows
The meter will display
arrow key to change to 3.
Figure 5
After setting
the zero flashing. Press the lb/kg key once. The
flashing. Press the zero key once to
the print key one time. Meter will show
zero key once. The meter should show
print key once, then the count key once. Meter should
be back in weigh mode. The printer is ready to use.
CO-1
. The one will be flashing.
C-16
. This is the date setting. Press enter. Use
C-18 0
. Press the zero key until
C18 6
. Then press the print key twice.
C19 3
. If not showing a 3, use
C19
, press the print key once to
CO-6
, then
C20
with
2
will be
C30
. Press
C30 0
. Press the
C30 1
. Press the
0319 IH-7978