Electric Wiring; Use And Maintenance - Airone IRIS Instrucciones Para El Uso, Mantenimiento E Instalacion

ASSEMBLY INSTRUCTIONS
Attention: Before proceeding with the installation, make sure that the screws and the anchors al-
ready supplied, are suitable for the type of wall the hood must be fixed to.
To assemble the hood use the accessories that are supplied and follow the instructions given in the en-
closed handbook.

ELECTRIC WIRING

The electric wiring must be performed by a specialised electrician fully respecting current standards and
legislation in force. Check that the power supply corresponds to the voltage requested by the hood,
which is given on the silver label stuck inside the hood. Ensure that the wiring system conforms to
current standards and the earth discharge works efficiently. Pay special attention to the hood power ca-
ble, ensure that it does not pass through any holes without a cable clamp. For direct connection to the
electrical mains is necessary to provide a device that ensures disconnection from the electrical mains,
with an opening distance of the contacts that allows the complete disconnection under the conditions
ofovervoltage category III, in accordance with the rules of installation.
The plug or omnipolar switch must be accessible when the unit is installed
If the power cord is damaged, it must be replaced by a special cord or assembly available from the manu-
facturer or its service agent. The cable used must be of type H05VV-F 3 x 0.75 mm2 minimum cross-
section.
The manufacturer declines all responsibility if the current accident prevention standards in force
are not respected, which are needed for the wiring system to operate correctly

USE AND MAINTENANCE

Before beginning any sort of cleaning or maintenance work, turn power off to the hood by turning
the main switch to 0 (OFF).
Changing the light bulbs
LED spotlight replacement should only be carried out by qualified technicians using only original spare
parts.
Cleaning the metal filters:
The metal filters fitted in the hood should be washed every 2-3 months, depending on how much the hood is
used, using hot water and a liquid detergent that is not too aggressive. The metal filters can be removed by
the special handle, unhooking the front part of the filter and pulling it downwards
EN - 5