Troubleshooting - Denon Professional DN-V200 Instrucciones De Operación

ENGLISH

20 TROUBLESHOOTING

Check again before assuming the player is malfunctioning
2 Are all the connections correct?
2 Are you following the instructions in the manual?
2 Are the amplifier and speakers operating properly?
If the DN-V200/DN-V300 does not seem to be functioning properly, check the table below. If this does not solve the problem, the DN-
V200/DN-V300 may be damaged. Turn off the power, unplug the power supply cord from the power outlet, and contact your store of
purchase or nearest sales office.
Symptom
Power does not turn on.
Playback does not start when PLAY
button is pressed.
Playback stops immediately.
Picture does not appear.
Sound is not produced or sound
quality is poor.
Menu playback is not possible.
Picture is disturbed during the
search operation.
Buttons do not operate.
No subtitles are displayed.
Audio (or subtitle) language does
not switch.
Angle does not switch.
Playback does not start when the
title is selected.
The password for rating level has
been forgotten.
The disc is not played with the
audio or subtitle language set as
the default setting.
Picture is not displayed in 4:3 (or
16:9).
Menu screen messages for the
desired language do not display.
60
• Plug the power supply cord securely into the power outlet.
• Is there condensation on the disc or player? (Let stand for 1 or 2 hours.)
• Discs other than DVDs, video CDs and music CDs and Digital picture (JPEG)
cannot be played.
• Disc is dirty. Wipe off the dirt.
• Check the connections.
• Turn "P.SCAN" off when a TV is connected to the VIDEO OUT and S-VIDEO
connector.
• Set the TV's input to "video".
• Check the connections.
• Properly set the input of the TV, stereo, etc.
• Check the "DIGITAL OUT" and "COMPRESSION" settings.
• Check the "AUTO PLAY" setting.
• Menu playback is not possible with anything but video CDs with playback control.
• Some disturbance is normal.
• Some operations are disabled for some discs.
• Check the "KEY LOCK" mode.
• Subtitles are not displayed for DVDs not containing subtitles.
• Subtitles are turned off. Turn the subtitles setting on.
• The audio (or subtitle) language does not switch for discs which do not include
multiple audio (or subtitle) languages.
• For some discs the audio (or subtitle) language cannot be switched when the
operation to switch it is performed, but can be switched on the menu screens.
• The angle cannot be switched for DVDs which do not contain multiple angles. In
some cases multiple angles are only recorded for specific scenes.
• Check the "RATING" setting.
• Use the procedure described below to set the initial settings back to the values
set when the unit was shipped from the factory. Input "1470" at 5 under step 3
on page 30.
• The disc does not play with the selected audio or subtitle language if that audio
or subtitle language is not included on that DVD.
• Set the "TV ASPECT" default setting to the proper setting for the connected TV.
• Check the default setting for the disc language's menu language.
Check Page
10~14
—
7, 8
9
10~14
10, 11
—
10~14
—
24, 25
30
33
—
33
52
—
27
—
44, 45
43
30
—
26, 27
22
27