Maintenance; Maintenance Schedule; Battery Maintenance; Fuel Valve Maintenance - Briggs & Stratton Husqvarna Manual Del Operario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance

Maintenance Schedule

Follow the hourly or calendar intervals, whichever occurs
first. More frequent service is required when operating in
adverse conditions noted below.
First 5 Hours
• Change engine oil
Every 8 Hours or Daily
• Check/clean water inlet screen
• Check high pressure hose
• Check detergent siphoning tube/tank
• Check spray gun and assembly for leaks
• Clean debris
• Check engine oil level
Every 25 Hours or Yearly
• Service engine air cleaner
Every 50 Hours or Yearly
• Change engine oil
2
Every 100 Hours or Yearly
• Service spark plug
• Inspect muffler and spark arrester
• Clean cooling system
2
Every 200 Hours or 3 Months
• Change pump oil
3
1
Clean if clogged. Replace if perforated or torn.
Service more often under dirty or dusty conditions.
2
3
Change pump oil after the first (50) operating hours and then every 200 hours
or 3 months thereafter.
General Recommendations
Regular maintenance will improve the performance and
extend the life of the pressure washer. See any qualified
dealer for service.
The pressure washer's warranty does not cover items that
have been subjected to operator abuse or negligence. To
receive full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual,
including proper storage as detailed in Winter Storage and
Long Term Storage.
NOTICE Should you have questions about replacing
components on your pressure washer, please call
(877) 224-0458 for assistance.
Some adjustments will need to be made periodically to
properly maintain your pressure washer.
18
1
2
All service and adjustments should be made at least once
each season. Follow the requirements in the Maintenance
Schedule chart above.
NOTICE Once a year you should clean or replace the spark
plug, clean or replace the air filter, and check the spray gun
and nozzle extension assembly for wear. A new spark plug
and clean air filter assure proper fuel-air mixture and help
your engine run better and last longer.
Emissions Control
Maintenance, replacement, or repair of the emissions
control devices and systems may be performed by any
non-road engine repair establishment or individual.
However, to obtain "no charge" emissions control service,
the work must be performed by a factory authorized dealer.
See the Emissions Warranty.
Before Each Use
1. Check engine oil level.
2. Clean debris.
3. Check water inlet screen for damage.
4. Check high pressure hose for leaks.
5. Check detergent siphoning tubes and tank for damage.
6. Check spray gun and nozzle extension for leaks.
7. Rinse out garden hose to flush out debris.

Battery Maintenance

Other than float charging, described elsewhere, no
maintenance is required for the starting battery. Keep the
battery and terminals clean and dry.
NOTICE Battery charging should be performed in a dry
location, such as inside a garage.
WARNING Battery posts, terminals and related
accessories contain lead and lead compounds - chemicals
known to the State of California to cause cancer and
reproductive harm. Wash hands after handling.

Fuel Valve Maintenance

The fuel valve is equipped with a fuel sediment cup, screen,
and o-ring that need to be cleaned.
1. Move fuel valve to "Off" position.
2. Remove sediment cup (A) from fuel valve. Remove
o-ring (B) and screen (C) from fuel valve.
C
B
3. Wash sediment cup, o-ring, and screen in a
nonflammable solvent. Dry them thoroughly.
www.usa.husqvarna.com

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido