4.0 Programming; Enter In Programming Mode; Programming Menu; Programming Menu Description - Aqua HC 997 Manual De Instrucciones

HC997 – MOD. B
Digital multifunction solenoid metering pump
3.3 A H/R
DJUSTING THE P
From the standby menu press three timer the
Press the
Press twice the key to go back at the standby menu.
After 10 seconds the pump automatically goes back to the standby menu if no key is pressed.

4.0 PROGRAMMING

4.1 E
NTER IN PROGRAMMING MODE
From the user menu, keep pressed the
To enter press the following key's combination:
4.2 P
ROGRAMMING MENU
4.2.1 P
ROGRAMMING MENU DESCRIPTION
Constant functioning menu
It allows to select among the following functioning modes:
Proportional functioning menu
It allows to select the following functioning modes:
proportional by external pulses from a water meter 1:N mode
proportional by external pulses from a water meter 1xN mode
proportional by external pulses from a water meter 1xN mode with memory
proportional by external 4÷20 mA current signal
PPM
proportional by pH
proportional by Rx
Timer functioning menu
It allows to programming the pump in daily or weekly timer mode.
Setting menu – Calibration
This menu allows to set all the functioning parameters of the pump and moreover to calibrate the pump.
ADSP9000030
X SETPOINT
keys to set the desired values ant then the
key for three seconds, the display will show:
Capacity – Period – Quantity to dose – Cyclical
key, the display will show the current setpoint.
key to confirm.
With the
choices.
To select the desired choice press
13/10/09
PROGRAMMING
keys is possible scroll the menu's
key
ENGLISH
28/88