Setting The Sunlight Threshold - SOMFY Sunis indoor WireFree RTS Guia De Instalacion

Installation guide
If the red/green LED is lit permanently, then demonstration mode is
deactivated.
If none of the buttons is pressed for 3 minutes in demonstration
mode then the sensor automatically switches to operating mode.

5.6. Setting the sunlight threshold

To increase the sunlight threshold, turn the potentiometer setting
toward the (+). To decrease the sunlight threshold, turn the
potentiometer setting toward the (-).
To adjust the threshold according to the
sunlight intensity of the moment, follow the
steps below:
1) Slide the (OFF/
2) Briefly press the (Mode) button: the LED
glows green or red.
3) Turn the potentiometer up to the (+) position:
the LED glows red.
4) Slowly turn the potentiometer towards the
(-) position until the LED changes from red
to green: the sunlight threshold is set on the
basis of the current intensity.
Copyright © 2010 Somfy SAS. All rights reserved.
) selector switch to
Sunis indoor WireFree™ RTS
.
+
9