Positioning Of The Sunis Indoor Wirefree™ Rts - SOMFY Sunis indoor WireFree RTS Guia De Instalacion

Installation guide
3) Press and hold the (PROG) button on
the already assigned RTS control point
until the end-product moves back and
forth: the motor or RTS receiver RTS
enters programming mode for 2 minutes.
4) Briefly press the (PROG) button on the Sunis
Indoor WireFree™ RTS. The end-product
moves back and forth: the Sunis Indoor
WireFree™ RTS is programmed.
Repeat operations 3 and 4 for each of the end-
products to be assigned to this sensor.
5.3. Positioning of the Sunis Indoor WireFree™ RTS
Clean the surface on which the sensor is to be mounted.
Check that there is nothing that can cast a shadow on the sensor.
5.3.1. On an inside window sill
1) Screw the suction cup to the bottom of the
sensor (A).
2) Moisten the suction cup.
3) Position the sensor with the sunlight intensity
detection area (B) towards the exterior and
press on the sensor to fix it in place.
6
Sunis indoor WireFree™ RTS
A
Copyright © 2010 Somfy SAS. All rights reserved.
B