Abicor Binzel ABIPLAS CUT 70 Instructivo De Servicio página 30

3 Product description
Type
Operating pressure
(flow pressure)
Torch inlet pressure [bar]
Air flow rate measured
with
Plasma air [l/min]
Soft start air [l/min]
Gas post flow time [s]
Selection of the plasma
nozzle
Tab. 3 Product-specific torch data (EN 60974-7)
The specifications on the cutting capacity are standard values only as they are also greatly
affected by the following factors:
• Type and quality of the material
• Compressed air pressure and impurities
• Temperature of the workpiece to be cut
• Desired cutting quality
• Condition of the electrode and the cutting nozzle
• Distance and position of the cutting torch from/in relation to the workpiece
• Power source characteristics
• Cutting speed
EN - 6
®
ABIPLAS CUT 70
®
ABIPLAS CUT MT 70
Nozzle bore 1.1 mm
Approx. 22
≥ 12
0.9 mm / to 30 A
1.1 mm / 30–60 A
1.2 mm / 50–70 A
1.1 mm long/max. 50 A 1.2 mm long/max. 50 A 1.2 mm long/max. 50 A
®
ABIPLAS CUT 110
®
ABIPLAS CUT MT 110
5–5.5
Nozzle bore 1.4 mm
Approx. 30
≥ 15
60
1.0 mm / 30–50 A
1.2 mm / 40–70 A
1.4 mm / 70–90 A
1.6 mm / 90–110 A
2.6 mm for gouging
®
ABIPLAS CUT
®
ABIPLAS CUT 150
®
ABIPLAS CUT MT 150
Nozzle bore 1.8 mm
Approx. 39
≥ 15
1.2 mm / to 70 A
1.5 mm / 70–90 A
1.6 mm / 90–120 A
1.8 mm / 120–150 A
3.0 mm for gouging
BAL.0099 • 2018-11-08