Cutting Depth Adjustment - Truper CAZ-EL-4-1/2N2 Manual De Instrucciones

Start up

Cutting depth adjustment

• Loosen the cutting depth control lever by moving it downwards.
• Fasten the base and lift the housing until the wheel shows from the base onto the desired depth. Use the depth guide as
reference.
• Press the cutting depth control lever with an upward movement to stop the housing from move in when you cut.
• The cutting depth may go up to 1.2"
CAUTION • In order to avoid accidents the cutting depth must be equal as the work piece thickness or to stick out
just a couple of inches.
Cutting depth
guide
Base
Cutting depth
control lever
Cutting angle setup (bevel cut)
• Loosen the cutting angle bracing knob.
• Fasten the base. Turn the housing until the disc reaches the desired angle.
• Tighten the cutting angle bracing knob to stop he housing from moving while cutting.
• The tool makes cuts from 0° up to 45°
Cutting angle
bracing knob
Water supply system
The water supply valve (1) allows opening and closing
the water flow in order to lubricate the wheel while
1
making a cut. The water supply should be delivered
from the sweet water mains.
• Disconnect the plug from the power outlet.
2
3
• Connect the water supply kit to the tool using the
Hose
supplied screw (2). Tighten firmly.
• With the faucet totally closed connect the faucet
adapter (3) to a garden hose or an exterior faucet.
CAUTION
It is not necessary to install the water
supply kit to make dry cuts.
8
ENGLISH