Nokia N93-1 Guia Del Usuario página 99

Packet data
Follow the instructions from your service provider.
Access point name—You obtain the access point name
from your network operator or service provider.
User name—The user name may be needed to make a data
connection, and is usually provided by the service provider.
Prompt password—If you must enter the password every
time you log in to a server, or if you do not want to save
your password in the device, select Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service provider.
Authentication—Select
Homepage—Depending on the access point you are setting
up, enter the Web address or the address of the multimedia
messaging center.
Select Options >
following settings:
Network type—Select the Internet protocol type to use:
IPv4 settings or IPv6
on the selected network type.
Phone IP address
of your device.
DNS address—In Primary name
of the primary DNS server. In
the IP address of the secondary DNS server. Contact your
Internet service provider to obtain these addresses.
98
Normal or Secure.
Advanced settings to change the
settings. The other settings depend
(for IPv4 only)—Enter the IP address
serv.:, enter the IP address
Second. name server:, enter
Proxy serv. address—Define the address for the proxy server.
Proxy port number—Enter the proxy port number.
Wireless LAN
Follow the instructions from your service provider.
WLAN netw. name—Select
for netw.. If you select an existing network,
mode and WLAN security mode
settings of its access point device.
WLAN netw. mode—Select
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
WLAN security mode—Select the encryption used: WEP,
802.1x (not for ad hoc networks), or WPA/WPA2. If you
select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the network
supports them.
WLAN security sett.—Enter the settings for the selected
security mode:
Security settings for WEP:
Wep key in use—Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
Authentication type—Select
authentication type between your device and the wireless
LAN access point device.
Enter manually or Search
WLAN netw.
are determined by the
Ad-hoc to create an ad hoc
Open or Shared for the