Initial Operation; Maintenance And Cleaning - Ubbink Cascademax 6000 Eco Manual De Instrucciones

1 Operating manual for Cascademax® waterfall and stream pumps

Initial operation

- Please read this operating manual carefully.
- Never let the pump run dry.
- Install the pump at a minimum depth of 250 mm and a maximum depth of 1000 mm below the water level on a stable surface that is free from sludge, sand and other
contaminants.

Maintenance and cleaning

The pump does not require lubrication or special maintenance. Just check the inlet slots on the filter housing from time to time for dirt and blockages, cleaning with clean water
where necessary.
If the pump is heavily soiled it must be dismantled:
1. Remove the hose connection with the hose connector and double sleeve.
2. Unscrew the locking ring from the pressure connector (see Fig. 1).
3. Press in the two click fastenings on the upper part of the housing and lift off the upper part (see Figs. 2 and 3). You can now clean the bottom and upper parts of the housing.
4. Undo the pump cover by turning the pump housing sideways (bayonet fitting). Now pull out the rotor from the motor housing (see Figs. 4–6). You can now clean the motor
and the rotor.
5. After cleaning, reassemble the pump in reverse order. Make sure the rotor is correctly installed and properly locked into the recesses in the motor housing.
How often the unit requires this level of cleaning depends on the respective operating conditions and degree of contamination of your pond.
In winter make sure the pump does not freeze up, so ensure you remove the pump from the pond in good time, clean the pump and store it in a frost-proof place, for example in
a bucket of water.
Cleaning/replacing the rotor
- Clean the rotor with a soft cloth. Never use use a chemical cleaning agent.
- To prevent damage, avoid contact with the ceramic drive shaft.
2
Warranty
We provide a warranty against defective materials and workmanship on this product of 2 years from the date of purchase. To make a claim against the warranty, the original
receipt must be submitted as proof of purchase. The warranty excludes complaints caused by installation and operation errors, insufficient maintenance, frost damage, incorrect
attempts at repairs, use of force, third party responsibility, overloading, mechanical damage or the effects of foreign matter. Also excluded from the warranty are all claims of
partial damage and/or problems caused by wear.
Declaration of conformity
The company UBBINK GARDEN BV declares under its sole responsibility that the pumps of its Cascademax® Fi series meet the requirements of the European Low Voltage Directive
2014/35/EU. The following harmonised standards were applied:
EN 60335-1:2012
EN 60335-2-41:2003+A1:2004+A2:2010
EN 62233:2008
Proper disposal for this product
Within the EU this symbol indicates that this product cannot be disposed of as household waste. Used devices contain valuable materials that should be recycled and
should not be allowed to damage the environment and human health through uncontrolled waste disposal. Therefore please dispose of used devices via suitable
collection systems or send the device back to the place where you bought it from. They will then send the device for material recycling.
Manual Cascademax 2017.indd 2 13-10-17 11:47