Install Multi-Function Door Control Panel - Merik 501M El Manual Del Propietario

LOCATE DOOR CONTROL PANEL (OR ANY ADDITIONAL PUSH BUTTONS) WHERE THE GARAGE DOOR
IS VISIBLE, AWAY FROM DOOR AND DOOR HARDWARE AND OUT OF THE REACH OF CHILDREN.
SERIOUS PERSONAL INJURY FROM A MOVING GARAGE DOOR MAY RESULT FROM MISUSE OF
OPENER. DO NOT ALLOW CHILDREN TO OPERATE DOOR CONTROL BUTTON(S) OR REMOTE
CONTROL TRANSMITTER.
FASTEN THE CAUTION LABEL ON THE WALL NEAR DOOR CONTROL PANEL AS A REMINDER OF
SAFE OPERATING PROCEDURES.
INSTALLATION STEP 7

Install Multi-Function Door Control Panel

Remove about 6mm of insulation from both ends of
2-strand bell wire. Connect one end to terminal
screws on back of door control as follows: the white
wire to the white terminal screw, and the white/red
wire to the red terminal screw.
Fasten the door control panel on an inside garage wall.
If installing into drywall, drill 4mm diameter holes for
anchors. A convenient place is alongside the service
door and OUT OF THE REACH OF CHILDREN.
Run bell wire up the wall and across the ceiling to
the opener. Secure with insulated staples.
Receiver terminals and antenna are located on back
panel of opener. Position antenna wire as shown.
Then connect the white wire to terminal screw 2 and
the white/red wire to terminal screw 1.
Control Button
OPERATION OF
LIGHTED DOOR CONTROL BUTTON
Press to open or close door.
Press again to REVERSE door during the
CLOSING cycle or to STOP door during OPENING
cycle.
Staples
Lighted Door
Metal Screws
6ABx1-1/2"
TO PROGRAM RECEIVER CODE
FOR EACH REMOTE CONTROL
1. Press and HOLD remote control
transmitter push button.
2. Press receiver code button. The opener
light will flash once.
3. Release transmnitter button. Opener
has learned code.
TO ERASE ALL RECEIVER CODES
1. Press and HOLD receiver code button.
Green indicator light alongside will turn
ON.
2. When light turns OFF (about 6
seconds) ALL codes are erased from
opener memory.
Back Panel
of Opener
WIRING INSTRUCTIONS FOR ACCESSORIES
The Protector System™
To opener terminal screws:
White to 2 and Black to 3
Outdoor Key Switch:
To opener terminal screws:
Red to 1 and White to 2
15
2-Strand
Bell Wire
2
Lighted Door
1
Control Terminal
Screws
Opener
Terminal
Screws
1 2 3
9 9
1 1
7 3 7 3
5 5
KG
KG
AVERTISSEMENT: Pour réduire les risques de
blessures mortelles par happement, après tout
réglage de la force de déclenchement ou des
seuils de fin de course s'assurer que le sens de
la course s'inverse lorsque la porte entre en
contact avec un object de 13 mm (1 po) de
hauteur (ou un madrier de 2 x 4 de section, à
plat) posé sur le sol. Effectuer les reglages
selon les procédures décrites dans la notice.
PART NO: Nº DE PIÈCE:
DATE:
Sears Roebuck & Co. D.O.C. CERT. NO.
Sears Canada Inc., Toronto
Assembled in Mexico - Assemblé du Mexique
PAT. #RE29,525; 4,750,201; 4,806,930 Other Patents Pending. M.D.C. CERT. NO. 132C2105-1
Antenna