TEFAL Largo Manual Del Usuario página 12

Ocultar thumbs Ver también para Largo:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Plugging in and preheating
Place the appliance on its support legs or on a stable
surface.
Avoid using "Bulgomme" tablecloth type plaint supports.
Never place the appliance directly on a fragile support
(glass table, tablecloth, varnished furniture, etc.).
To avoid overheating of the appliance, never place it in a
corner or against a wall.
Unroll the cord completely.
Check that the electrical installation is compatible with
the power and voltage indicated on the bottom of the
appliance.
Only plug the appliance into earthed sockets.
Supply the appliance through a residual current device
(RCD) having a tripping current not exceeding 30 mA.
If an extension cord is used:
- this must be earthed and rated accordingly;
- take all precautions necessary to ensure that no one
will get tangled in it.
The supply cord should be regularly examined for signs
of damage and the appliance is not to be used if the cord
is damaged.
If the power supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
Open the protective cover (1).
Insert the control unit (4) fully into the appliance and
then plug into the mains: the pilot lamp lights up.
The control unit (4) cannot be inserted when the cover is
closed.
Do not use any other control unit (4) other than the one
supplied with your appliance.
Never plug in the appliance while the protective cover (1)
is closed.
Never leave the appliance plugged in while it is not in
use.
Never use the appliance when empty.
Do not use charcoal or any other combustible material in
the appliance.
Set the thermostat to the Max position.
Allow the appliance to preheat for approximately
10 minutes.

Publicidad

Tabla de contenido
loading

Tabla de contenido