Troubleshooting - Kenmore 665.7527 Manual De Uso Y Cuidado

4. Slowly pull drawer all the way out.
To Replace:
1. Align silver tabs on the drawer glides with the receiving holes
in the drawer.
2. Push drawer down one side at a time, inserting the silver tabs
into the receiving holes, locking drawer in place.
3. Gently open and close the drawer to ensure it is seated
properly on the slides.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Cookware should not extend more than 1/2"(1.3 cm) outside
Nothing will operate the cooking area.
i,
• Is the power outlet properly wired and polarized? Oven will not operate
Try another outlet to check for proper wiring and polarity.
• Is the power supply cord unplugged?
Plug into a properly grounded 3 prong outlet.
• Is the power outlet properly wired and polarized?
Try another outlet to check for proper wiring and polarity.
Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Is the main or regulator gas shutoff valve in the off
position?
See Installation Instructions.
Is the range properly connected to the gas supply?
Contact a Sears trained repair specialist or see Installation
Instructions.
Is this the first time the oven has been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.
Is the electronic oven control set correctly?
See "Electronic Oven Control" section.
Is the Oven Lockout set?
See "Oven Lockout" section.
Triple Task Oven Drawer will not operate
Surface burners will not operate
• Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.
• Is the self-clean cycle on?
The oven drawer will not operate when the self clean cycle is
on.
Oven burner fails to light
• Is the Cooktop Lockout set?
See "Cooktop Lockout" section.
• Is the control knob set correctly?
Push in knob before turning to a setting.
• Are the burner ports clogged?
See "Sealed Surface Burners" section.
Surface burner flames are uneven, yellow and/or noisy
• Are the burner ports clogged?
See "Sealed Surface Burners" section.
• Are the burner caps positioned properly?
See "Sealed Surface Burners" section.
• Is propane gas being used?
The appliance may have been converted improperly.
Contact a Sears trained repair specialist. See back cover.
Surface burner makes popping noises
• Is the burner wet?
Let it dry.
Excessive heat around cookware on cooktop
• Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner.
• A household fuse has blown, or a circuit breaker has tripped.
• The ignition system is broken. Contact a Sears trained repair
technician. See back cover.
Oven makes muffled ticking noise when in use
• This is normal and occurs when the oven burner cycles on
and off to hold the set oven temperature.
Oven burner lights, then goes out after I minute
• Press STOP/CLEAR, then wait 1 minute before trying again.
• Is the power outlet properly wired and polarized?
Try another outlet to check for proper wiring and polarity.
Oven burner flames are yellow or noisy
• Is propane gas being used?
The appliance may have been converted improperly. Contact
a Sears trained repair specialist. See back cover.
Oven temperature too high or too low
• Does the oven temperature calibration need adjustment?
See "Oven Temperature Control" section.
))))))))))))))))))))))
21