Solar 4001 Manual Del Proprietário página 13

Recharging Onboard Batteries
NOTE: Ensure that the Battery Type Indicator Switch is properly set to match the onboard batteries (AGM or
Flooded/Wet Cell). This will ensure a proper charge and improve battery life.
1. This step for 12/24V configuration only. For 12V or 24V configurations, skip to Step 2. Connect Voltage
Selector Quick Connect to Charging (Red) Quick Connect Assembly on unit handle.
2. Plug female end of included power cord into the receptacle on the back of the Control Cabinet. Plug male
end of power cord into AC outlet.
3. CHARGING LED will light to indicate charging is in progress.
NOTE: When charging cord is first connected, Charging LED will flash several times before lighting solid.
If flashing continues, this indicates an internal wiring error. Disconnect charging cord and check internal
connections.
4. When the onboard batteries are fully recharged, the CHARGE COMPLETE LED will light. The unit features
a fully automatic charging system, which eliminates the possibility of overcharging the batteries. As a result,
the unit can be left connected to AC indefinitely with no adverse consequences.
13