Controls And Indicators - Solar 4001 Manual Del Proprietário

CONTROLS AND INDICATORS

Control Cabinet Front
The front panel of the Control Cabinet features important status indicators related to two functional areas, Jump
Starting and Recharging the Unit.
Jump Starting Indicators include:
GOOD CONNECTION DETECTED
This indicator signifies that a correct vehicle connection has been made. This allows the Boost
Mode to be engaged. Boost Mode engagement cannot occur if this LED is not lit.
BOOST MODE ENGAGED
This indicator signifies that the unit is fully powered to perform the jump start. The duration of
the Boost Mode is determined by the Timer setting (See Control Cabinet Top).
VOLTAGE ERROR
When the Voltage Selector is engaged in either the 12V or 24V position, the VOLTAGE ERROR light will
be lit until a proper battery connection has been made, at which point it will turn off and the green GOOD
CONNECTION DETECTED LED will light. After a battery connection is made, if the VOLTAGE ERROR LED is
lit, it indicates that an abnormal voltage condition has been identified. For example, if the unit were set to 12V
mode and then connected to a 24V system, this condition would trigger this error. When this LED is lit, Boost
Mode engagement cannot occur
REVERSE POLARITY
This indicator will light when the unit detects that it has been connected in reverse fashion. When
this LED is lit, Boost Mode engagement cannot occur.
Recharging Indicators Include:
CHARGING
This indicator will light when the unit is connect to AC supply and the onboard batteries are charging.
CHARGE COMPLETE
This indicator will light when the onboard batteries have reached full charge. The unit can remain
connected to the AC outlet indefinitely with no adverse consequences, as the charging system is fully
automatic and there is no risk of overcharging. The charging system will maintain the onboard batteries until
the unit is next needed for jump starting.
4