Perry Electric 1GA47917MET/P Instrucciones Para La Instalación página 19

2.i - ELECTRICAL CONNECTIONS
IMPORTANT: the installation and electrical connection of
devices and appliances must be carried out by qualified
personnel and in compliance with standards and laws in
force. The appliance is suitable only for applications in
household or similar environments. For application in special
environments, see specific environment standards.
The examples given in this documentation are indicative.
WARNING: the main appliance's must include a device
ensuring omnipolar disconnection.
The detector must be powered continuously in order to
guarantee maximum safety.
For the electrical connections, attach the detector terminals using
2
cables of cross-section 1.5 mm maximum.
Connection procedure
switch mains supply off 230V~ 50-60 Hz
Connect 230V ~ power supply to the terminals:
n° = 1 Line
n° = 2 Neutral
Connect the controlled device to the terminals:
n° = common 3
n° = normally open contact 4
n° = normally closed contact 5
In the case of BUS connection to other
detectors/indicators, use the terminals:
n° = " " 6
BUS
n° = " " 7 +
For the connection of several appliances to a BUS
line, see the next chapter.
The diagrams ( purely guideline
the position of the relay contacts at rest (no alarm)
examples) show
NC solenoid valve
(manual re-arm)
Fig. 16a:
Example: connection to normally
closed solenoid valve
NO solenoid valve
(manual re-arm)
Fig. 16b:
Example: connection to normally
open solenoid valve (manual re-arm)
230V~ 50÷60 Hz
EN
230V~ 50÷60 Hz
19