Displaying Defined Measurement Tasks (Set-Project) - WEBTEC HPM540 Manual De Instrucciones

6.4 Displaying defined measurement tasks (SET-PROJECT)
Up to five different measurement tasks (PROJECT) can be configured
in the PC software. Certain sensors are defined for each input. These
definitions can be retrieved in SET-PROJECT.
It is only possible to alter this setting using the PC software.
V2.0/02.11
Device settings (SET)
Input 1
Wrong sensor connected!
Please use measurement range 100
bar.
Input 4
Correct sensor connected
FS = 600 L/min
97