Insert Or Replace Batteries; Time And Date Of System Setup - VM TensioFlash KD-795 Manual

INSERT OR REPLACE BATTERIES

When LCD shows battery symbol, replace all
batteries with new ones.
1. Slide the battery cover in the direction of the
arrow to open.
2. Insert 2 alkaline AAA batteries in the correct
polarity direction. Inserting them incorrectly may
damage the device and the warranty. Never use
rechargeable batteries. Use single use batteries.
3. Replace the battery cover.
Disposal of empty battery to the authorized
collecting party subject to the regulation of each
individual territory.
If the unit will not be used for a long period, please take
out all batteries to avoid liquid leakage damaging the unit.
With the use of 2 alkaline "AAA" batteries, you can measure
more than 50 times at room temperature of 72°F (22°C) and
inflating to around 170mmHg once a day. But the included
batteries only for test purpose may not last as specified
long period.
36 Visiomed - KD-795 - 032016

TIME AND DATE OF SYSTEM SETUP

1. When the machine is turned off, press
the button "START" and "MEMORY" at
same time, the number of month will
glitter on LCD. Press button "START"
continuously, the numbers of month,
date, hour, and minute will glitter.
While the number is glittering, press
button "MEMORY" the corresponding
number will increase by 1. Hold on
pressuring the button "MEMORY" the
number will increase fast.
2. After pressuring "START" button the fifth time, numbers
on LCD will not glitter, then you exit the time adjusting
mode. See picture.
Note: Please check and re-set Date/Time after replacing of new
batteries.
Visiomed - KD-795 - 032016 37