How To Use The Wrist Cuff; How To Measure Blood Pressure - VM TensioFlash KD-795 Manual

HOW TO USE THE WRIST CUFF

1. Put off your watch and any jewel from
your left hand.
2. Hold your left wrist with your palm
facing up; apply the cuff so that the
display of monitor is in easy to view
position.
3. The cuff's edge should be approxi-
mately 1/4 to 1/2 inch (1~2 cm) below
your palm.
4. Wrap the cuff snugly around your wrist, the top and bot-
tom edges of the cuff should be tightened evenly around
your wrist and lower arm.
5. When the cuff is positioned correctly, secure it in place by
pressing the pile material firmly against the sewn hook
material.
6. Sit in a chair with your feet flat on the floor and place
your left arm on a table with your palm facing upward.
The cuff should be at the same level as your heart.
Note: Your heart is located slight below your armpit If the cuff is not
at the same level as your heart or if you cannot keep your arm com-
pletely still throughout the measuring, use the store box or other
soft object to support your arm.
7. Remain seated quietly for two minutes before you begin
the measurement.
Notes :
- If it is not possible to fit the cuff to the left arm, it can also be
placed on the right arm
- If the cuff is dirty, clean it with a damp cloth.
40 Visiomed - KD-795 - 032016

HOW TO MEASURE BLOOD PRESSURE

1. After your body is in a comfortable position, press the
"START" button. After a long "beep", BPM will verify itself,
and all LCD will glimmer automatically.
2. If it already has memory, then LCD will show the last re-
sult. If machine does not have memory before, the LCD
will show of four "0", while it verify itself
3. If the voice function is on, the monitor will speak out the
measurement tips with that language. After two seconds
(maybe longer because of verifying itself ), LCD shows one
"0". Then the machine begins to pressurize automatically.
4. After measurement, the result of systolic, diastolic and pulse
rate will all display on LCD. And irregular heartbeat symbol
and blood pressure classification indicator will glimmer. The
result will be automatically memorized by itself.
5. Pressing "START" button after measuring, machine will
be turned off. It will be automatically power off after 1
minute of none use
Notes:
- The value measured will be too low if you hold your cuff higher
than heart level, or will be too high if you hold your cuff lower
than heart level.
- The unit may store 60 measurement values, If more than
60 records, it will delete the earliest data.
- During measurement do not speak or shake as is may affect the
accuracy of the result.
- If you want to stop the measurement during measurement
process, just press the START button to stop immediately.
- Please consult a health care professional for interpreting pressure
measurements.
Visiomed - KD-795 - 032016
schema .
41