Honda Prelude 1988-1991
1. Remove (2) Phillips screws
located below the climate controls.
(Figure A)
2. Remove (1) Phillips screw from
each side of the dash console and
(2) Phillips screws from each side
of the floor console. (Figure A)
3. Remove the plastic dummy cap
from the end of the dash console
and (2) Phillips screws exposed.
(Figure A)
4. Pull the floor console out and
gently remove the dash console.
5. Remove (6) Phillips screws
securing the factory radio and
disconnect the wiring.
6. Cut and remove all of the mounting
clips on Radio Housing (a) EXCEPT
clips "A" and "C" (the clips can be
identified by the stamped letter
near each clip). (Figure B)
Continue to kit assembly
Dash Disassembly
(Figure A)
"A"
"C"
"A"
"C"
(Figure B)
®
INST-7898
Honda Prelude 1992-1996
1. Remove (2) screws from the top of
the console trim bezel.
2. Slide the front seats back and
remove (4) Phillips screws from
each side of the bezel. (Figure A)
3. Pull up on the console trim bezel
and remove.
4. Using an angled screwdriver,
remove (2) screws securing the
gear shifter bracket to the bezel.
5. Remove (4) screws from the radio
trim bezel, remove the factory
radio assembly and disconnect the
wiring. (Figure A)
6. Cut and remove all of the mounting
clips on Radio Housing (a) EXCEPT
clips "F" and "H" (the clips can be
identified by the stamped letter
near each clip). (Figure B)
Continue to kit assembly
12
(Figure A)
"F"
"H"
"F"
"H"
(Figure B)