Accord 1998-2002; Civic 1996-1998 - Metra INST-7898 Instrucciones De Instalación

Acura/honda/isuzu 1988-2006
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Honda Accord 1998-2002
1. Unsnap the clock panel, disconnect
the wiring and remove. (Figure A)
2. Remove (1) Phillips screw exposed
in the clock cavity.
3. Remove (2) Phillips screws below
the factory radio.
4. Unclip the radio trim bezel and
disconnect the wiring. (Figure A)
5. Remove (4) Phillips screws securing
the factory radio assembly and
disconnect the wiring.
(Figure A)
Dash Disassembly
6. Remove (2) screws securing the
factory pocket to the assembly.
7. Cut and remove the mounting clips
from Radio Housing (a).
8. Locate tabs "A" on the mounting
brackets for mounting, cut and
remove tabs "B" (the tabs can be
identified by the stamped letter near
each tab). (Figure B)
9. Secure the brackets to the housing with
(4) #8 x 3/8" Phillips pan head screws .
Continue to kit assembly
"A"
(Figure B)
®
INST-7898
Honda Civic 1996-1998
1. Remove (2) Phillips screws from
the bottom edge of the glove box
door and remove the door.
2. Remove (3) Phillips screws from
the lower steering column panel.
3. Pull straight down on the lower
steering column panel and remove
the panel.
4. Remove (2) Phillips screws under
the climate control panel.
(Figure A)
5. Remove (4) Phillips screws from
the lower dash location.
6. Remove (2) 8 mm hex head screws
securing the bottom-rear of the
factory radio and disconnect the
wiring.
7. Locate Radio Housing (b). (Figure B)
Continue to kit assembly
7
(Figure A)
(Figure B)

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

99-7898bb

Tabla de contenido