Powerspot THERMIX Manual Del Usuario página 30

Thermix can reach 20V over the ade-
quate flame, although the voltmeter in-
cluded can only indicate up to 17.3V. With
this tension the fan will release a power-
ful heat air stream, but its life will be se-
verely shortened. If it is going to be used
as a heater, we suggest that it does not
surpass the 15V if you desire to fulfil the
50,000 hours guaranteed by the manu-
facturer.
Ideally, Thermix provides two 9W light
points (1,600 lumens). However, it can
slightly light up at least ten points, which
is usually enough for a family house. You
must take into account that every time
you add a light bulb the voltage will be
reduced slightly, and each light bulb will
shine less. Therefore you will have more
light points but with lower intensity.
30
All the PowerSpot thermoelectric gen-
erators can be connected in a series or
in parallel, increasing therefore the to-
tal available power for the same circuit.
If you wish to fit this kind of installation,
Powerspot offers the adequate peripher-
al cable.
Also, all the PowerSpot generators can
send power to a pre-existent electri-
cal installation in a house. For that, the
generated electricity can be sent to each
socket of the electrical installation so this
is fed by it. Substituting light bulbs al-
ready installed by 12V LED bulbs, or by
the ones manufactured by PowerSpot,
and unplugging those devices that re-
quire more than 15W (TV sets, fridges
etc.), the power will reach any socket al-
ready existing in a house.