Installing Hdx Cassettes And Adapter Plates - Leviton HDF3168 Guia Del Usuario

Tray Release Label
Warning: Each patch deck tray has a stop point at the fully opened and closed positions. Forcing a
tray past these points may damage the Deck and locking tabs.
Removal of trays from the front
1. Slide the target tray forward. The tray release lever will engage at the front stop point.
2. Open the label window, press the tray release lever and slide the tray forward.
Removal of trays from the rear
1. Slide the target tray forward to the front stop point.
2. Open the label window and gently press sideways towards the louver to release the right
retention pin. Remove the label window. Press the tray release lever and slide the tray rearward
past the front stop point until the tray exits the deck.
3. From the rear of the frame pulling rearward, remove the tray from the deck
4.4

Installing HDX Cassettes and Adapter Plates

Install HD cassettes or adapter plates by following these steps:
1. Slide the target tray forward to the front stop point.
2. Lift the label window.
3. Insert the cassette or adapter plate as shown in Figure 14.
4. To Remove Press down on the release button and slide the cassette or adapter plate forward to
remove (Figure 15).
DI-000-F3168-20B
Leviton HDF3168 Fiber Distribution System User Guide
Figure 13
Figure 14
23