Ordering Accessories; Replacing The Filter; Replacing The Side Brushes - Philips FC8778 Manual Del Usaurio

Ocultar thumbs Ver también para FC8778:

Tabla de contenido

Idiomas disponibles

Replacement

Ordering accessories

10 Insert the snap hooks of the TriActive nozzle into the holes in the bottom

of the robot. Push the TriActive nozzle back into position. Make sure that

the TriActive nozzle can move a few millimeters up and down freely. If the

TriActive nozzle cannot move freely, disassemble it again and then

reassemble it carefully.

To buy accessories or spare parts, visit www.philips.com/parts-and-

accessories or go to your Philips dealer. You can also contact the Philips

Consumer Care Center in your country (see the international warranty leaflet

for contact details).

Replace the filter if it is very dirty or damaged. You can order a new filter

under order number FC8012. See 'Emptying and cleaning the dust container'

in chapter 'Cleaning and maintenance' for instructions on how to remove the

filter from the dust container and how to place it in the dust container.

Replace the side brushes after some time to ensure proper cleaning results.

Note: Always replace the side brushes when you notice signs of wear or

damage. We also recommend that you replace both side brushes at the

same time. You can order spare side brushes as a set under order number

FC8013.

1 To replace the side brushes, grab the old side brushes by the bristles and

pull them off their shafts.

English

Tabla de Contenido

Tabla de contenido