General Characteristics; Contents Of The Box - Dolphin PRO OEM 24.40 Manual Tecnico

GENERAL CHARACTERISTICS

NOT_PRO_OEM-00
Maintenance precautions
To prevent any risk of electric shock
during maintenance operations, ensure that the
following recommendations are scrupulously
observed before performing any maintenance
on the device:
4All maintenance operations must only be
carried out by a suitably qualified technician.
4In the event of damage to the mains leads
and/or batteries, these may only be replaced by
a qualified person, to avoid any danger.
4The mains power supply must be
disconnected (cable or switch).
4 The -DC or -BAT supply on the battery must
also be disconnected to prevent any transfer of
power.
4To allow the high voltage capacitors to
discharge (on the circuit board), wait for 5
minutes before carrying out any work inside the
housing.
4The fuses must be replaced by fuses with strictly
identical characteristics and performance levels.

CONTENTS of the BOX

NOT_PRO_OEM-00
RECEIPT OF THE PRODUCT
Contents of the packaging
4The charger.
4Wall mounting bracket
Checking
Check the product's identification
label, attached to one side of the
product, to ensure that the tech-
nical details actually meet your
needs (mains supply voltage, charger capacity,
etc.).
Installation introduction
The charger should be mounted using the wall
mounting bracket. The mounting bracket should
be mounted on a robust wall, using two Ø 5
screws. The charger clips onto the wall mount,
which is attached to the wall by 2 Ø 5 screws.
Ideally, the product should be in a vertical
position, with the cable outlet pointing
downwards. Clearance of at least 10 cm must be
allowed around the device to guarantee
optimum convection, in particular along the sides
allowing the air needed for ventilation to flow in
and out.
The circulation and convection direction of the
air inside the charger is from right to left, viewed
from the front of the product (see photo below).
UK