Seko OPL-ADVANTAGE Manual De Instalación página 13

OPL-ADVANTAGE – OPL system
3.2.8 Load count
The load count pump of the OPL-ADVANTAGE performs a number of important functions.
10) Counts total loads for each formula.
11) Terminates programmed lockout times (see par. 3.1.8).
12) Activates the system reset timer
13) Resets "levels" on pumps 1 – 6. NOTE: The pump used for load counts accepts only 1 wash level.
Select the last pump to receive a signal during any wash formula. The pump designated for load count must
receive a signal at the end of the formula. A signal should be received even if the pump will not dispense
chemical for the selected formula.
3.2.9 Setting the load count pump:
1) Enter access code (see par. 3.2.1).
2) Press ENTER.
3) The pump time and delay time LED's will be off and the current load count pump will be briefly
displayed in the pump window.
4) Use PUMP SELECT key for selecting the load count pump number. The display flashes during
selection of the desired load count pump.
5) When the pump time LED returns (in 3 seconds)

The END pump is the same for all formulas.

Note in DRAIN mode the END PUMP is PUMP 2 by default.
3.2.10 Displaying the load count
Access code is not required to display load counts.
Normal mode
1) Press ENTER; The load count will be shown on the 3-digit window for the formula displayed; the
single digit display located directly below the "CAL" key shows the END PUMP
To see the statistic for each formula and pump, perform the following procedure:
1) Formula: Press FORMULA SELECT to select the formula.
2) Press PUMP SELECT to select the pump.
3) If you set Formula 0, the 3-digit display reveals the total loads count for all formulas.
4) Clear load counts by pressing
Drain mode
The programming procedure is the following:
1) Repeat the procedure to enter in DRAIN mode. (See par. 3.2.11 below)
2) Use FORMULA SELECT to display desired formula.
3) Press ENTER. The load count will be shown on the 3-digit window for the formula displayed; The
END PUMP is displayed in the window directly below the "CAL" key.
4) After 5 seconds, the display flashes and returns to its previous appearance.
5) Clear load counts by pressing
Repeat these steps for all formulas.
OPL-ADVANTAGE
the pump number was accepted
while the count is displayed until the 3-digit display shows 000.
while the count is displayed until the 3-digit display shows 000.
code 0000136607 rev. 1.6 EN 11