Description Of The System - Seko OPL-ADVANTAGE Manual De Instalación

OPL-ADVANTAGE – OPL system
1.4

Description of the System

Description and function of keypad:
1) KEY : Is used to increase programmed run and delay
times or set the drain count in "Drain" mode. Hold down
to scroll rapidly.
2) KEY Is used to decrease programmed run and
delay times or to set drain count in "Drain" mode. Hold
down to scroll rapidly.
3) RESET KEY: Restarts the system during a
programming step.

CAUTION!!! Reset does not erase all data from
memory.
4) TIME MODE: For scrolling to the desired feed and
delay times. Also, for designating Drain counts in Drain
mode. (Pump time led will be blinking when setting feed
times and delay time led will be blinking when setting
delay times).
5) CAL (Calibrate) KEY: Allows product volumes to be set
by calibration. Press this key to start pump while
measuring output. Press again to stop. This will set the
pump for that volume in the selected formula.
6) PUMP SELECT KEY: Use this key to select the pump
to be calibrated or programmed.
7) PRIME KEY: After selecting a pump, press this key to run for the programmed time.
8) ENTER/LOAD COUNT KEY:
a) To check load counts when in RUN MODE press this key to show load count for the formula
displayed.
b) To skip lockout time in RUN MODE.
c) To reset to level one.
d) To select "END" Pump. This is necessary for correct programming.
9) FORMULA SELECT KEY: This key scrolls through formula numbers to program, edit or run.
Description of displays
The 3-digit display shows:
Pump run and delay times
-
Drain counts in DRAIN mode
-
Load counts
-
The PUMP display shows:
The PUMP/TRIGGER number; LEVEL 1 or LEVEL 2 and F "Flush mode".
-
The formula display shows:
The number of formula, r "relay mode" and A for programming
-
OPL-ADVANTAGE code 0000136607 rev. 1.6 EN 3