MSA 92048 Guia Del Usuario página 10

thinner, lacquer thinner, or any
chlorinated organic solvents.
Removal of light scratching and
smoke stains can be achieved
through the use of Meguiars
Mirror Glaze Plastic Cleaner
#M1708 and Clear Plastic Polish
#M1008.
3. Reinstalling the Defender Lens
a. Slide each quick-connect down
into each slot from where it was
removed. The quick-connects
will "click" into place when fully
engaged.
b. Re-attach cloth heatshield to
velcro hook fasteners on impact
cap.
Note: Position cloth heatshield as
close to the suspension headband as
possible so to not contact front
mounting screws on underside of
brim.
Helmet Shell - Remove
Faceshield/Goggles/Bourkes/
Defender Lens before cleaning
1. Thermoplastic Shell [Models 360R,
360R-13, 360S, and 880]:
a. To clean, use mild cleaning
agents such as ethyl alcohol or a
mild detergent and water, and a
soft sponge or cloth. NEVER use
abrasives, solvents paint
TAL 134 (L) Rev. 21 - 10043529
MAINTENANCE
10
removers, acetone, paint or lac-
quer thinner, or any chlorinated
organic solvents. Removal of
light scratching and smoke
stains to thermo-plastic helmets
can be achieved through the use
of Meguiars Mirror Glaze Plastic
Cleaner #M1708 and Clear
Plastic Polish #M1008.
2. Fiberglass Composite Shell
[Models 660C Metro, 664, 1010,
1044, HP3]:
a. To clean, use only mild solvents,
such as ethyl alcohol, mild
detergents and water, mild abra-
sives, industrial cleaners (such
as DuPont
tone, or paint remover.
3. Leather Shell [Models N5A and
N6A]:
a. To clean, use only mild deter-
gents and lukewarm water. To
remove dripping of tar, industrial
cleaners (such as DuPont
Remover) can be used. Use only
on tar spots, not the entire sur-
face. Other spots can be
cleaned with alcohol if an organ-
ic solvent is required. Markings
or touch-ups can be done with a
good quality enamel.
4. Flannel Headband Liners and
Defender Lens cloth heatshield [All
Models except N5A and N6A]:
a. To clean flannel headband liners,
machine wash and dry on low
settings.
INSPECTION
1. Inspect the helmet, including all
accessories after EACH use for
impact, thermal, and use damage.
® Tar Remover), ace-
® Tar