Declaración De Conformidad Del Fabricante - U.S.Robotics SureConnect 8500 Instalación

Declaración de conformidad del fabricante
Declaramos bajo nuestra exclusiva responsabilidad que el U.S. Robotics USB ADSL
Modem, al que se refiere esta declaración, es conforme a las siguientes normas u
otros documentos normativos:
Normas CE: Normas CE: Normas CE: Normas CE: Normas CE:
EN55022 Clase B (EMC)
•
EN55024 - (Inmunidad)
•
EN60950 - (Seguridad)
•
Emisiones: (EE.UU.) FCC Parte 15 Clase B, (Canadá) ICES-003
Seguridad: (EE.UU./Canadá) CSA C22.2 Número 950-95 NRTL/C
Telecomunicaciones: (EE.UU.) FCC Parte 68, (Canadá) Industry Canada (CS-03)
FCC Class B Certification FCC Class B Certification FCC Class B Certification
FCC Class B Certification FCC Class B Certification
This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference
that may cause undesired operation.
Warning! Warning! Warning! Warning! Warning! This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential in-
stallation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there is no guarantee that in-
terference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the distance between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from the one
•
which the receiver is connected to.
Consult the dealer or an experienced radio/TV technician for help.
•
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
Attach standard telephone cable to the RJ-11 port, and shielded USB cable to the USB
port.
NO NO NOT T T T T E: E: E: E: E: In order to maintain compliance with the limits of a Class B digital device, NO NO
US Robotics requires that you use a quality interface cable when connecting to this
device. Changes or modifications not expressly approved by US Robotics could void
the user's authority to operate this equipment. Suggested cable type is 90-ohm USB
cable for the USB port, and standard telephone cable for the RJ-11 port.
26 26
26 26 26