Caring For Your Device - ResMed AirStart10 APAP Guia Del Usuario

More options
Your care provider may have given you access to personalize a few more options.
Pressure Relief When Pressure Relief is enabled, you may find it easier to breathe out. This
can help you get used to therapy.
Mask
This option shows your mask type setting. If you use more than one type of
mask, adjust this setting when switching between masks.
Run Warmup This option allows you to pre-heat the water before starting therapy, so that
the air is not cold or dry at the beginning of therapy.

Caring for your device

It is important that you regularly clean your AirStart 10 device to make sure you receive optimal
therapy. The following sections will help you with disassembling, cleaning, checking and
reassembling your device.
Disassembling
1. Hold the water tub at the top and bottom, press it gently and pull it away from the device.
2. Open the water tub and discard any remaining water.
3. Hold the cuff of the air tubing and gently pull it away from the device.
4. Hold both the cuff of the air tubing and the swivel of the mask, then gently pull apart.
Cleaning
You should clean the device weekly as described. Refer to the mask user guide for detailed
instructions on cleaning your mask.
1. Wash the water tub and air tubing in warm water using mild detergent.
Do not wash in a dishwasher or washing machine.
2. Rinse the water tub and air tubing thoroughly and allow to dry out of direct sunlight and/or heat.
3. Wipe the exterior of the device with a dry cloth.
English 7