Connectors; Connecting Other Equipment - Disney TV-Princess Manual Del Usuario

Disney-TV-Princess_MD3723-22.book Seite 9 Montag, 14. Juni 2004 4:33 16
Fitting the loudspeakers
For sound output, the loudspeaker must be fitted.
• Place the loudspeaker on the TV set, fitting the
plug-and-socket connections between loudspea-
ker and TV set. The underside of the loudspeaker
must be flush with the TV set.

Connectors

Antenna connector
To connect to the house antenna or cable system, connect a double-screened cable from the an-
tenna socket to the television set.
Headphone connection
On the front of the set is a headphone socket, suitable for any normal headphones fitted with a 3.5-
mm jack plug. When headphones are in use, the loudspeakers are turned off.
CAUTION!
Too high a volume, especially when using headphones, can damage your hearing. For this
reason, you should turn the volume right down before connecting the headphones.
Power connection
Do not connect the appliance to the mains until you have made all the other connections. Insert the
device's plug into a mains socket (230 V ~ 50 Hz) that is close to the place where you have set
the up the device.

Connecting other equipment

The SCART socket on the rear and the Audio/Video outputs on the front panel can be used to con-
nect various audio and video appliances (video-recorders, SAT receivers etc.).
To connect an external appliance, connect it
• either with a SCART cable (SCART socket on rear of TV)
• or with audio Cinch cables (AV connectors on front panel of TV).
Please note the instructions regarding additional equipment in the operating instructions.
GB-9