Care And Cleaning - Kohler K-1695 Manual Del Propieratio

Operating Your Steam Generator
NOTE: Refer to the instructions packed with your digital user interface and media module.
Normal Operation
"GEN TEST" LED is blinking green once every second (one second ON and one second OFF).
"TEMP SENSOR" LED is blinking green once every second (one second ON and one second OFF).
"DATA LINK" LED is blinking green once every second (one second ON and one second OFF).
Abnormal Operation (see the Troubleshooting Procedures for more information)
"GEN TEST" LED is OFF, ON flashing red, ON solid green, or ON solid red.
"TEMP SENSOR" LED is OFF, ON flashing red, ON solid green, or ON solid red.
"DATA LINK" LED is OFF, ON flashing red, ON solid green, or ON solid red.
The Power Clean Function
WARNING: Risk of personal injury. Stay out of the showering area when the power clean function
is activated.
NOTICE: Users will be automatically reminded to use power clean after 600 minutes of steam generator
use. The steam generator may be run three times before the power clean function must be run. Failure to
initiate power clean after the third reminder will result in the system locking. Power clean must then be
run in order to resume steam operation.
NOTE: When the power clean function is activated, water will typically discharge from the steam head.

Care and Cleaning

For best results, keep the following in mind when caring for your KOHLER product:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care &
Cleaning information, call 1-800-456-4537.
Kohler Co. 3 1069332-5-C