Bosch TS1013 Manual Del Usuario

BM 2610015699 12-10:BM 2610998790 12-07 12/17/10 9:25 AM Page 1
BOSCH D DO INSERT TS1013
Read and understand the manual for use of this acces-
W RNING
sory with the tool.
1. Remove plug from power source, and remove the blade guard
assembly.
2. Lower the blade completely below the table surface.
3. Lower the riving knife (GTS1031 only) to it's lowest position and lock
into place. See the GTS1031 Table Saw Operating/Safety Instructions
Manual for detailed instructions.
4. Position table insert in pocket of table so tabs on insert are in slots in
pocket of table and push down and secure in place.
Adjusting the table insert
The table insert should be adjusted so it is flush with the saw table sur-
face (Fig. 1).
The GTS1031 table insert slot includes four (4) adjustment screws to set
the height (Fig. 2). Place the insert onto the table. Place a straight edge
(such as the metal ruler from a combination square) across the table top
and insert top – the surfaces should be at the same level (Fig. 1). If
adjustment is necessary, use the included 2 mm "L wrench" (packed with
GTS1031) to rotate each set screw up or down.
Never operate the saw without the proper insert in place. Use the saw
insert when sawing and the dado insert when dadoing.
Always reattach blade guard assembly for all thru cuts.
Installing accessory outer dado washer
(GTS1031-series only)
Prior to installing or cutting with a dado set, see the Dado and Molding
Cutting section of your GTS1031 Table Saw Operating/Safety
Instructions Manual for complete installation and user instructions.
The enclosed "outer" accessory dado washer is for use with a dado set
on the Bosch GTS1031 Table Saw only.
Your accessory "outer" dado washer is designed to secure a maximum
1/2" dado set with the arbor nut in place, as shown in the diagram below.
(Fig. 3)
Do not use the accessory "outer" dado washer for standard cuts without
a dado set. See your GTS1031 Table Saw Operating/Safety Instructions
Manual for how to return your saw back to normal "thru-cutting."
FIG. 3
RBOR
RBRE
EJE PORT HERR MIENT
DE L ME INTÉRIEURE
R NDEL INTERIOR
INNER BL DE
W SHER
RONDELLE
DE L HOJ
INNER BL DE
L ME INTÉRIEURE
HOJ INTERIOR
FIG. 1
T BLE INSERT
ÉLÉMENT MOVIBLE
INSERCIÓN DE L MES
FIG. 2
LEVELING SCREWS
VIS DE MISE À NIVE U
TORNILLOS NIVEL DORES
CHIPPERS
L MES
DÉCHIQUETEUSES
OUTER BL DE
STILL DORES
L ME EXTÉRIEURE
HOJ EXTERIOR
LEVELING SCREWS
VIS DE MISE À NIVE U
TORNILLOS NIVEL DORES
CCESSORY D DO W SHER
RONDELLE CCESSOIRE
POUR L ME À R INURER
R NDEL CCESORI
P R MORT J R