Aleratec 1:3 DVD/CD Auto Publisher LS Guia De Inicio Rapido página 14

9. Select the "Height of Robotic Arm" parameter and adjust with
the "Up" and "Down" arrow buttons as necessary. The picker
head should be flush with the surface of the disc on the tray,
but should not press down so hard as to put undue pressure on
the tray. Click "Accept" when finished with this parameter, and
remove the disc from the recorder.
10. The alignment
parameters for Number
1, 2, and 3 Spindles are
all performed with a
stack of 90 discs in each
bin, with the guide peg
resting in the center hole
of the stack of discs.
Use the "Right" and "Left" arrow
icons to move the robotic arm
clockwise and counterclockwise,
respectively, to reach the closest
position possible. Press "Accept"
when finished aligning each bin
position.
11. Number 4 Spindle is for rejected discs, and it is aligned in the
same way as the previous step, albeit without any discs on the
spindle.
12 www.aleratec.com
Disc Retaining
Surface of the
Picker
Disc Retaining
Surface of the Tray
Center Guide